INSTALLATION

 INSTALLING SUMP PUMP

BESTBATTERYBACKUPSUMPPUMP

STEPS:

1.FINDING AN LOCATION :

a) where water gets collected .

b) should be near GFCI (Ground Fault interrupter Outlet ) / SWITCH. 

2.DIGGING A HOLE FOR THE SUMP:

a) Average 6 inch deep & 10 inch wide .

b) Average 3 inch Gravel in the bottom .

c) place the sump 

3.ADD MORE GRAVEL :

a) Pour more Gravel around sump.

b) leave 1 or 2 inch of the sump exposed.

4.ATTACHING THE ADAPTER:

a) Male adapter should be glued to PVC discharge pipe .

b) Place into female adapter on the pump .

c) Put an hole in discharge pipe around 6 inch up the pump.

5.INSTALLING AN CHECK VALVE :

a) Pump’s electrical cord should be attached to discharge pipe .

b) Check valve to be installed on the discharge pump.

c) Put the pump into sump.

6.CHANNELING WATER AWAY :

a) Use Pressurized fitting

b) PVC should be preferred to pump water away from home .

7.PLACE PVC OUT THROUGH WALL :

a) Make hole through wall for PVC.

b) Incase of Block wall , use hammer .

c) Incase to break a brick , use rotary hammer

8.APPLY SEALANT TO HOLE :

a) Silicon Sealant to be preferred .

b) Drag the ousted water atleast 4 feet away from the wall of house.

9.COVERING THE SUMP BASIN:

a) Gravel should be put around the pipe .

b) Sump Pump should be plugged .

c) Cover the sump basin.